853-040482-525 power adapter

853-040482-525 power adapter 

Product Details Introduction

-Wear an anti-static wristband before operation to avoid damaging module components due to static electricity

-The module should be used in an environment of 15 ° C~35 ° C, away from high temperature and humid environments

-When connecting coaxial cables, ensure that the interface is tightened to avoid poor contact and signal loss

-Check the cable for any damage, short circuit, or open circuit, and confirm that the connection is reliable before powering on

-During initial debugging, the output power of the RF power supply is first adjusted to around 50W, and then gradually increased

-During the debugging process, focus on observing the reflected power and try to make the forward and reverse power ratio ≥ 10:1

-After replacing the system terminal, it is necessary to adjust the matching status again from low power

-Sufficient shielding ground should be reserved near the module to ensure signal transmission stability

-High frequency signal lines should be shortened as much as possible to avoid sudden changes in line width, and arc routing should be preferred

-Silk screen printing should not be printed on high-frequency signal lines to prevent impedance changes from affecting performance

-The module should be well grounded to avoid induction heating or spark phenomena

-Avoid cross winding of power cords and coaxial cables to reduce signal interference

-It is recommended to record the parameters of the debugged knob, which can be quickly fine tuned and matched after restarting

-Regularly clean the interface with anhydrous ethanol to remove dust and oxide layer

-When repairing, the power supply must be cut off first, and before opening the cover, confirm that there is no residual high voltage

853-040482-525 Product imag

853-040482-525 ontroller Module

HONEYWELL 90088-A-9001 Output module
CI687K01 3BSE043660R1 Processing logic module
FLN3524A Processing logic module

Other website links

Triconex 2101安全系统卡件
IC695CPE310-ACAT中央处理器
560CMU05远程通讯模块