AMAT Applied Materials DP-200-5F Controller Module

AMAT Applied Materials DP-200-5F Controller Module

Product Details Introduction

Known parameters

Model: DP-200-5F

Input: Three phase AC power supply 200 V, 50/60 Hz

Output: 200 V DC voltage, maximum 5 A

Control mode: Supports CV (constant voltage), CC (constant current), CP (constant power)

Control mode: It can be controlled locally or remotely

Function and Features (Inference/Common Design)

The following are common functions or features of this type of controller, suitable for the intended use:

Multi control mode switching

In different application scenarios (such as driving loads, heaters, electromagnetic coils, etc.), it is necessary to control voltage or current in different ways. This module supports CV/CC/CP modes and can adapt flexibly.

Local and remote control interface

The module may have panels, indicator lights, switches, etc. for on-site operation; Simultaneously supporting remote signal input (analog voltage/current or digital commands) for control by the upper system.

protection mechanism

To ensure safety and safe operation of the equipment, this module may have the following protective functions:

overcurrent protection

Overvoltage/undervoltage protection

short circuit protection

over-temperature protection

Fault detection/alarm output

Stable output, low noise

In DC output, it should have good stability, low ripple, and low noise to be suitable for equipment with high requirements for power quality.

Heat dissipation and structural design

There may be heat sinks or air ducts designed inside the module to dissipate internal heat loss. The module may be slot type or cabinet mounted for easy integration of the entire machine.

Reliability and environmental adaptability

In the semiconductor equipment environment, high requirements are placed on temperature, vibration, electromagnetic interference, cleanliness, etc. Therefore, the module design should have strong anti-interference ability, reliability, and lifespan.

System compatibility and interface matching

The module needs to be compatible with the control bus, signal wiring, electrical grounding, and grounding methods of the entire equipment system to ensure correct control and safety.

AMAT Applied Materials DP-200-5F  Product imag

AMAT Applied Materials DP-200-5F  Related website links

ABB 560CMU05 Serial port module
IC695CPE310-ACAT Gas turbine card
TB852 3BSC950263R1 Terminal module

Other website links

ABB RED670显示面板
Bently 3500/50 133442-01位置监视器模块
Bently 3500/50 133434-01转速计 I/O 模块