The main products

Spare parts spare parts, the DCS control system of PLC system and the robot system spare parts,

Brand advantage: Allen Bradley, BentlyNevada, ABB, Emerson Ovation, Honeywell DCS, Rockwell ICS Triplex, FOXBORO, Schneider PLC, GE Fanuc, Motorola, HIMA, TRICONEX, Prosoft etc. Various kinds of imported industrial parts

Products are widely used in metallurgy, petroleum, glass, aluminum manufacturing, petrochemical industry, coal mine, papermaking, printing, textile printing and dyeing, machinery, electronics, automobile manufacturing, tobacco, plastics machinery, electric power, water conservancy, water treatment/environmental protection, municipal engineering, boiler heating, energy, power transmission and distribution and so on.

EATON MPB2-TP Connect the module

IMMPI01 Multifunction Processor Interface The IMMPI01 Multifunction Processor Interface module handles the I/O interface between the host computer and the INICT03 module. The IMMPI01 module supports either SCSI or RS-232-C computer interface. When communicating through the RS-232-C port, the module can act as data communication equipment (DCE) or data terminal equipment (DTE).The IMMPI01 module is a single printed circuit board that occupies one slot in the module mounting unit. The circuit board contains microprocessor based communication circuitry that enables it to communicate with its INICT03 module through the ribbon cable connection. The IMMPI01 module has three card edge connectors for external signals and power (P1, P2, and P3). Connector P1 connects to common and +5 VDC power. Connector P2 is not used. Connector P3 is used to cable connect the module to an NTMP01 termination unit. The P6 connector is used to cable connect the IMMPI01 module to the INICT03 module. For RS-232-C computer interface, the module cable connects to an NTMP01 termination unit. Two RS-232-C ports are located on the termination unit. The NTMP01 jumper configuration determines DTE or DCE operation. For SCSI computer interface, the SCSI port (P5) is located at the module faceplate. In this case, no termination unit is required.

Host Computer 

The host computer can connect to the INICI03 interface in two ways. It can connect using a SCSI communication cable from the SCSI port on the IMMPI01 faceplate to the SCSI port on the host computer. Or, it can connect from its RS-232-C port to an RS-232-C port of an NTMP01 termination unit. The termination unit cable connects to the IMMPI01 module. Two RS-232-C ports are located on the termination unit. Features The Cnet-to-computer interface has the following features: • Cnet provides a plant-wide communication network. • Cnet provides time-synchronization across the control system plant wide. • Each node can operate independently of other Cnet nodes. • Computer interface modules provide localized startup and shutdown on power failure without operator intervention. • Fast response time. The ten-megabaud communication rate gives timely information exchange.

• The INICT03 module packages process information for maximum transmission efficiency. • The computer interface modules handle four message types: broadcast, time-synchronization, multicast and NIS poll. • All messages contain cyclic redundancy check codes (CRC) and checksums to insure data integrity